Air filters are a crucial component of your HVAC system. These filters help to protect your home and family from harmful particles, allergens, and pollutants.

Installing an air filter in your HVAC system can be a difficult task. It requires a lot of time and knowledge to make sure that the filters are installed properly.

If you live in the GTA and are looking to install heating and air conditioning filters in your HVAC system, you must have the right tools for the job.

The following article will provide you with all the information you need to know about how to install an air filter in your HVAC system.

Air filters are essential for the health of your HVAC system. They remove dust and other particles from the air and keep your home or office environment clean. You can contact our heating and cooling services in the GTA for guidance, or for us to come and do it for you! After all, we’ve been in the business for over 15 years.

The steps to install an air filter in your HVAC system are outlined below:

The first step is to find out where the air filter is located. You can find this information by looking at the sticker on your HVAC unit. The sticker will have a number that corresponds with a location on the unit. It may also have a letter that corresponds with a location on the unit as well.

Open the furnace filter. If you can’t open it, look for a small release lever near the bottom of the unit.

Check to see if there are any screws on the outside of your unit that might need to be removed before opening it and look for a release lever near the bottom of your unit – this will help you open it without damaging anything inside.

Once you’ve opened your furnace or AC unit’s service door, turn off the power to the AC unit by unplugging it from its power source. Then locate the filter and remove it from its housing (usually located in one of these areas: Top left corner, top right corner, middle left, or middle right).

Pull out the old filter and dispose of it properly to ensure fresh, clean air flowing through your office or home.

Install a new filter by screwing it into place, making sure to press it firmly against all surfaces. Reattach two screws that hold down one end of the new filter.

Make sure everything is working properly before turning on your HVAC system again.

How Often Should I Change the Air Filter?

The average lifespan of an air filter is around six months. This means that you should change the filter every six months or so. However, the life span can vary depending on the type of filter and where and how it’s installed in your HVAC system.

If you want to do it yourself, check out our line of filters available on our website. You can also contact us to make sure you’re getting the best quality for long-term use or book an appointment and we can come and do it for you!

This entry was posted in Uncategorized and tagged H